Page
28
of
55
Operati
on
Accelerator
Fig. 13 - Accelerator
pedal
Fig. 14 - Steering
The CM2
XL
has an accelerator pedal on the
right side of the vehicle.
By pressing the pedal forward, the vehicle moves
forward. The speed is regulated depending on the
pressure intensity on the pedal.
The machine is reversed by pulling the pedal
backwards with the foot. The speed is regulated
depending on the pull intensity on the pedal.
Steering
The CM2
XL
has a very tight turning radius due
to the wheel geometry. The chain-guided
steering is translated via the steering wheel to
the rear wheel. This allows turning in narrow
passages and spaces on the spot.
Fig. 15 -
Speed control
Regulating engine speed
During operation, set the throttle position
according to the desired engine speed.
Throttle lever pulled out:
high speed ↑
Throttle pushed in: low speed ↓
Fig. 16 - Controls
Hydraulic controls
Upper hand lever:
Hand lever pushed forward
- Hydraulic pressure on the red connector
Hand lever pulled backwards
- Hydraulic pressure on the yellow connector
Lower hand lever:
Hand lever pushed forward:
Raises the hoist
Hand lever pulled backwards:
Lowers the hoist
