4. Installation
4.1. Mounting the Router
The router is fitted with a DIN-rail clip by default. To attach the router to a DIN-rail:
1. Position the router so that the spring of the DIN-clip rests on the DIN-rail.
2. Push the router in an upward direction so that the spring of the DIN-clip compresses and the top hook of
the DIN-clip slides and clamps to the DIN-rail.
To remove the router from the DIN-rail, simply reverse the procedure.
MOUNTING HEIGHT
To reduce the risk of personal injury and damage to the device, the unit must not be mounted
at a height greater than two metres above the ground beneath it.
4.2. Cooling
This product uses convection cooling. Spacing is recommended for the use of the product in full operating
temperature range and service life. To avoid obstructing the airflow around the product, use the following
spacing rules.
Minimum spacing of 25 mm (1 inch) above/below and 10 mm (0.4 inches) left/right of the product is
recommended.
REDUCE THE RISK OF FIRE
To reduce the risk of fire, use only telecommunication line cords with a cable diameter of
AWG 26 or larger. Regarding power cable dimensions, see chapter Interface Specifications.
4.3. Connecting Cables
Connect one end of the Ethernet cable into port A and the other end to your PC or switch.
4.4. Connecting the Antenna
If only connecting one LTE antenna, screw the antenna into the MAIN SMA connector. If you are using more
than one LTE antenna, screw the main antenna into the MAIN SMA connector and the secondary antenna into
the WAN-AUX SMA connector.
Merlin 4400 Series
15
