g) Press on the drive carrier lever until there is an audible click. This means the drive is securely locked
into place.
h) Install the remaining drives in the last row.
i) Continue to populate the drive bay rows, one at a time, until the enclosure reaches the expected capacity.
Attention: If the enclosure will not be fully populated, it is required that the row following the last
drive populated row be filled with drive blanks.
j) Place the cover on top of the chassis and slide towards the rear of the enclosure until fully seated.
Figure 34: Drive Bay Cover—Seated
k) From the front of the enclosure, turn the thumbscrews clockwise until the cover is secure.
Figure 35: Drive Bay Cover—Thumbscrews Clockwise
7. Seat and secure the enclosure into the rack.
62
11
System Upgrades
Installation Guide
11.2
Drive Kits
