Western Shelter Systems WS-VC-CBTA, Quick Start Manual

8

2. Vinyl Assembly

Ø

Drape roof panel over upper folding 

framework. 

Ø

Attach the roof panel to the arched eave bar 

starting at the center and working to the 

ends, stretching it as you go. Look for the 

vinyl weld or marking arrow to align with 

the center screw on the bar. Do not attach 

the sides of the roof yet, as they go over the 

walls. 

Ø

The walls are labeled Left Side and Right 

Side, which refers to the boot when viewed 

from the trailer looking toward the shelter. 

Ø

Hang the wall by aligning the angled portion 

of the wall with the angled receiving block. 

Work out from the middle to both ends. The 

end of the wall panel should align with the 

trailer-side end of the roof panel, about 5 

inches past the eave bar. Attach both walls.

Ø

Secure the four clips on the walls, located 

near the trailer end, and tighten the straps 

until they are just snug. Do not over-tighten 

or bunching may occur in the vinyl. Do not 

secure the lower straps yet. 

Ø

Starting at the trailer end and working 

towards the shelter, attach roof sides to the 

walls. Pull the roof edge over the sides and 

attach to the fastening strip.