Lit. No. 94430/94431, Rev. 09
18
October 1, 2018
RECEIVER MOUNT
Removing the Spreader
1. Unplug the spreader.
2. Remove the pin from the receiver hitch.
3. Remove the spreader from the vehicle and stand it
in an upright position. This may require additional
support.
REMOVING THE SPREADER
CAUTION
During removal or mounting, securely grip
spreader to avoid dropping.
FIXED MOUNT
Removing the Spreader
1. Unplug the spreader and CHMSL (if equipped).
2. Remove the two 3/8" cap screws, washers, and
locknuts that fasten the spreader to the bumper of
the vehicle.
3. Use an additional person or clamps to support
the unit and then remove the four 3/8" cap screws
and locknuts that fasten the spreader to the top
brackets.
4. Remove the spreader from the vehicle and stand
in an upright position. This may require additional
support.
Removing the Brackets
1. Remove the two 1/2" cap screws, washers,
and locknuts that fasten each top bracket to the
bed rail.
2. Remove the two 5/16" cap screws, washers, and
locknuts that fasten each top bracket to the side of
the bed rail.
3. Package the brackets with all hardware and store
them with the unit.
CAUTION
Empty the hopper before removing the
spreader.