12
Electrical accessories
The "(S)" symbol indicates that the option is present as standard in the unit, provided this is not in conflict with other
selected accessories.
DAA
Double power supply with automatic switching
A motor-driven automatic switch to which to connect two separate power supply lines (for example, one from
the mains power line and one from the uninterruptible power supply unit) is installed in the electrical control
panel of the unit.
The switching from one line to another is automatic and obligatorily requires passing through the OFF position.
DAM
Double power supply with manual switching
A manual switch to which to connect two separate power supply lines (for example, one from the mains power
line and one from the uninterruptible power supply unit) is installed in the electrical control panel of the unit.
The switching from one line to another is manual and obligatorily requires passing through the OFF position.
When this accessory is requested, the power supply of the unit must compulsorily include neutral.
GLO
Modbus Lonworks Gateway
With this accessory, a RS485/Lon gateway is installed inside the electrical control panel.
By default, the programming gives read-only access to the control of the unit. Enabling of read/write access
should be requested when ordering.
FMx
Multilogic Function
The Multilogic function allows management of up to 32 units equipped with advanced Bluethink controller and
connected in hydraulic parallel with each other.
On the basis of the information recorded by the temperature probes installed on the delivery and return man-
ifolds of the system, with the master unit, a capacity request is generated that is distributed among the units
connected in the Multilogic network according to settable priority and optimization logics.
If communication between the units fails or if the master is off-line, the slave units can continue to work ac-
cording to the set thermoregulation parameters.
The connected units can be different from each other, in terms of capacity and set-up, provided the following
rule is complied with: if there are both free cooling and non free-cooling units in the Multilogic network, the
Master unit must obligatorily be one of the free-cooling units.
The Multilogic function that can be requested with the unit can be:
•
FM0:
Multilogic function for Slave unit
•
FM2:
Multilogic function for Master unit for managing up to 2 Slaves
•
FM6:
Multilogic function for Master unit for managing up to 6 Slaves
If you need to connect more than 6 slaves (up to 31), you can ask for a quotation from our sales department.
For the slave units, the accessory requires:
•
programming of the unit as slave of a system of machines in Multilogic network
For the master units, the accessory requires:
•
programming of the unit as master of a system of machines in Multilogic network
•
entering of the parameters necessary for connection with the individual slave units
•
installation in the electrical control panel of a network switch to allow the units to be connected in a LAN
network.
•
the supply of 2 temperature probes to be positioned on the delivery and return manifold of the system (sup-
plied separately with it, installation and wiring by the customer)
