16
Replacing the Sanding Belt
Replacing the Sanding Belt
1. In order to replace the sanding
belt, remove the cover from the
side.
2. Loosen the handwheel (12) that is
located at the upper pulley. The
upper pulley now can be pulled
down against the tension of the
spring until the sanding belt can
be detached from the roll. Mind
the correct grinding direction of
the sanding belt when inserting
the new sanding belt. The grinding
direction is indicated by arrows
that are printed on the inner side
of the sanding belt. Below the
handwheel you will find the ten-
sioner (10) for the pulley. By
turning up or down the nut on the
threaded bar, the tension of the
spring can be increased or de-
creased.
3. After inserting a new sanding belt always check the running performance
of the new sanding belt. Do this by moving the sanding belt by hand. In
case the sanding belt moves to the left or to the right, you can use the fine
tuning provided by the upper pulley to
correct this behaviour.
Fine tuning can be performed with the
help of the adjusting screw (11) that
is located below the handwheel.
Turning in the adjusting screw will lift
the position of the pulley’s outer end
in order to move the sanding belt to
the left. Turning out the adjusting
screw will lower the position of the
pulley’s outer end in order to move
the sanding belt to the right. Perform
these adjustments having removed
the side cover. You will have a better
overview of the pulley then.
Adjusting Screw
Summary of Contents for 46 28 38
Page 1: ...Westfalia Bedienungsanleitung Nr 108416...
Page 4: ...III 1 2 3 4 5 7 8 11 10 9 6 12...
Page 25: ...20 Notizen Notes...
