Operation
10
Removal
For the removal of the SAC clutch, follow the instructions of the
installation in reverse order. The use of the centring tools is not
necessary.
Repositioning
When operating the new clutch disc with a used clutch pressure
plate it is necessary to reset the adjusting ring of the clutch
pressure plate.
Position the pressure piece with the pressure spindle on the
fixing screws and tighten.
Now use the resetting tool.
With the aid of the pressure spindle, press the diaphragm spring
of the clutch pressure plate until the adjusting ring moves to the
right.
Re-position the adjusting ring by turning the resetting tool to the
left.
Do not exert force on the adjusting ring when applying the
resetting tool.
Turn back the pressure spindle. Remove the pressure piece, the
pressure spindle, the resetting tool and the fixing screws.
Maintenance, Cleaning and Storing
To prevent serious injury from accidental operation and/or tool
failure:
Do not use a damaged tool.
Clean the tool set with a clean dry cloth only. Do not use any
cleaners, solvents, water, or other liquids.
Store the tool in the carrying case, in a clean and dry location out
of reach of children.
