23
Operation
Triangle
Allen Wrench
40
Fig. 5
43
49
Fig. 4
Adjusting the Sanding Belt (Fig. 4)
Belt adjustment is factory set, so
that the sanding belt will run
centrically through the driving
wheels.
1. If the sanding belt does not
run straight, adjust the run of
the sanding belt with the
adjusting handle (49).
2. If you turn the handle
clockwise, the belt moves to
the right (facing the sander).
By turning counter clockwise the belt will move to the left.
Adjusting the Sanding Table (Fig. 5)
For most work, mount the sanding table to 90° angle to the
sanding belt. The sander is equipped with a positive stop in order
to enable quick positioning the sanding table to 90° angle to the
sanding belt.
Adjust the positive stop as follows:
1. Loosen the locking handle (43)
and position the table to visual
judgement to 90°.
2. Use a right-angled triangle.
Place the one leg of the trian-
gle, as shown, on the table and
hold the other leg against the
sanding belt. Check, if the table
is in 90° angle to the belt.
Adjust the table if necessary.
3. If the table surface is in 90° angle to the belt, tighten the set
screw (40) on the upper end of the table as far as possible.
