9
Technical Data
Mounting and Connection
Attention: Only qualified personnel are allowed to work
on electrical systems in vehicles. For installing the
LED work light observe the regulations and safety
instructions.
For mounting the LED work light on the vehicle, use
the included mounting material (3) and the bracket (2)
or other bolts or screws that are suitable for the
ground.
In road transport always switch off the LED work light!
1. Connect the
black
cable with the
minus
pole of the
battery or with a non-painted surface of the chassis.
2. Finally connect the
red
cable to the
plus
pole of the
battery.
Hints:
Operate the LED work light with an ON/OFF switch
(e. g. a toggle switch) in order to switch on the light
only when it is needed. When using a switch, make
sure the switch is equipped with a current load
rating of at least 12 A .
Do not operate the work light unnecessarily as this
will shorten the life span of the LED.
Maintenance and Cleaning
Clean the LED work light frequently to maintain full
brightness.