15
Operating
1. Insert the tubes into each other and hand tight only. Please observe the arrow
markings on the tube ends.
2. Insert the branch cutter into the suitable branch cutter mount (11) and tighten
the branch cutter with the knurled screw in order to prevent the unit from
falling out.
3. Press the button PUSH (12) in order to tilt the branch cutter mount about 90°.
To align the branch cutter mount back to straight position, press the button
PUSH again. Move back the tiltable mount until it locks audibly.
4. To switch on the branch cutter while connected with the base and
supplemental extension sets, press the safety switch (2) to the left or to the
right and hold the safety switch pressed. Than press the ON/OFF switch (3).
5. To switch off the branch cutter, release the ON/OFF switch. The blade
automatically moves back to initial position.
