Instruction Manual
III
Assembling
1. Assemble the three handles together with the
black threaded ends. Turn them clockwise in
order to tighten.
2. Tighten the mop holder on the white threaded
end on the handle.
3. Place the mop on the floor and attach the mop
holder onto the mop. Press down the mop
holder with the foot until the mop holder locks
audibly.
4. To remove the mop, step on the fibres
– not on
the mop holder
– and pull out the mop holder
from the mop.
5. Disengage the rotation mechanism (A) on the
handle by turning counter clockwise.
Using
1. If desired you can lock both buckets together. Slide the bucket with the
spin basket along the guiding on the second bucket. Fill the bucket
(without the spin basket) up to the marking with water and add
detergent.
2. Immerse the mop into the bucket until it is completely soaked.
3. Place the mop into the spin basket.
4. Push down the handle in order to wring out the water. Due to the fast
rotation, the water will be wrung out. Repeat the procedure several
times depending on the wetness you require for cleaning the floor.
Cleaning and Storing
After use remove the plug from the discharge opening of the spin
basket bucket. Rinse the buckets thoroughly with water.
Clean the mop at max. 40° C. Do not use any fabric softeners.
Store the set indoors in a dry place that is protected from dust, dirt and
extreme temperatures.
(A)
