WESTFIRE · WF
32
WESTFIRE · WF
32
9
instaLLing tHe aPPLianCe
i) remove door and frame
a. Open door to 90 degrees
b. Remove safety plate with allen key on top hinge
c. Lift door so bottom hinge pin is out of the holding hinge plate
d. Tilt base away from stove and lower door
e. Door should now be released
f. Place door in a safe place
ii) remove frame from stove
a. Once door is removed
b. Loosen four Allen keys and frame will come away
iii) remove Brick set
a. See manual below
iV) remove Bar from flue collar
a. Loosen bolts holding flue collar
b. Remove flue collar taking care not to lose nuts and bolts.
V) fit collar to stainless steel flue( we recommend a 500mm
of 1mm stainless steel if possible)
Vi) fill any Void with at the back and sides with a 6;1 vermiculite
to cement mix or any other good quality non-combustible
insulation material. it is important that the back and sides of
the stove are well insulated.
Vii) Connect the stove to the flue
a. Pull stove collar to top of stove from inside the appliance
b. Align bolt locations and re-bolt the spigot (and Flue) to stove
c. Tighten bolts and secure
Viii) finish around stove
iX) re-fit frame
a. If a newly plastered room please take care not to leave painted
frame and door fitted as the extremes of moisture while the
plaster dries and can cause corrosion to the paint work
b. Before re-fitting door and frame, store door and frame in a dry
and well ventilated place while allowing the plaster to dry
X) re-fit door
Xi) re-fit brick as shown in the instructions in this booklet.
To remove frame, after removing door,
unscrew 4 allen keys securing ther frame.
uk
Summary of Contents for WF32/UNIQ32 Freestanding
Page 31: ......
