Read this Instruction manual carefully to ensure proper installation. Please keep this instruction manual for future use.
MUST KNOW ABOUT THIS FIXTURE:
• This solar fixture is equipped with a dusk to dawn sensor only to turn on when darkness is detected.
• The fixture is designed to stay on with dimmed brightness all night and switch to full brightness when
motion is detected. The fixture isn’t intended to stay on 100% brightness continuously.
• The average direct sunshine exposure in the installation area should be at MINIMUM 3.5h/day to ensure
the full functionality of the lighting fixture.
• The working temperature of the solar fixture is - 4 F to 104 F. But the Battery will stop charging at below
32 F.
• Battery power is less than 40%; the brightness will automatically be reduced by 50% .
• The indicator blinks green slowly when there is less than 10% battery power. When the charge is less than
5%, the fixture will shut down.
• The Battery drains every four months when not charged adequately by sunlight or electricity.
MUST DO BEFORE INSTALLATION:
1. Before installation, please check the battery to see if it’s fully charged. Please proceed to theinstallation on
sunny days. Please see the indicator color guide on page 3
2. Before installation, please press the ON/OFF key in the remote control and check whether the
redindicator blinks on the sensor. Please cover the panel and check if the indicator module turns
on,generally within 1 minute. If the light is still off, try the ON/OFF key on the remote one more time. Ifthe
indicator doesn’t blink red upon restart, contact the manufacturer.
3. (Before installation) Select the necessary operation mode with the remote control. Please refer
tothe instruction manual for the remote control for further information. Note: the fixture is best set
at20%constant brightness with lumen increase when motion is detected. See the remote controlsettings
on page 2.
4. Before installation, please ensure the light pole foundation is solid enough to withstand the lightingfixture.
5. Optimize the lighting fixture positioning to optimize its exposition to sunshine. Always face theequator.
(Solar panel to face south if in the northern hemisphere, for example)
6. To allow self-cleaning, please have a minimum angle of 15 degrees.
7. Adjust the lighting fixture angle to optimize its exposition to sunshine and the LED module angletoward
the area too bright up.
8. 8.Use the dedicated tool to disassemble the anti-theft screws. Note Dedicated tool not included orsold
separately.
9. Please select the correct operating mode according to the local legislation needs and sunshineconditions.
See the solar radiation map on page 4.
1
Phone: (877) 805-2252 | Fax: (877) 805-2252
www.westgatemfg.com |
SOLF
VOLTAGE
WATTAGE
COLOR TEMP.
DIMMING
SOLF-17W-50K
120-277V AC
17W
5000K
Use the remote control
to adjust
SOLF-36W-50K
36W
SOLF-54W-50K
54W
WARNING
Installation Instructions
OUTDOOR LIGHT
