7
0800 328 5708
•
www.westhillbikes.com
3.3 Adjusting the wheels
Tighten the screws to make sure the front and back wheels are fixed to
•
the front fork and frame.
Recommended tightening torques are as follows:
•
Front wheel hub: 18Nm
Rear wheel hub: 30Nm
3.4 Adjusting and maintaining the brakes
Grease and insert the brake cable in the housing.
•
Use a 5-mm Allen wrench and a tightening torque of 6–8 Nm to secure
•
the cable to the brake body.
Align the brake pads 1 mm below the upper edge of the wheel rim.
•
Position the brake pads 1 mm from the wheel rim using the adjustment
•
screw located on the brake lever.
Check that the wheels spin freely, without being hindered by the brake
•
pads.
Check if the spinning wheels touch the rim on one side, if so; adjust the
•
screw.
Check that the brakes stop the wheel when the brake lever on the han-
•
dlebars is activated. The brake lever travel must be no greater than 2.5
cm.
Adjusting screw
Summary of Contents for AEC-TDE16Z
Page 1: ...Electric Bike User Manual ...
