12 | Westinghouse Outdoor Power Equipment, LLC
ASSEMBLY
ASSEMBLY
CARTON CONTENTS
Weight hazard. Always have assistance when lifting the
generator.
1.
Carefully open the carton.
2.
Remove and save the instruction manual, oil bottle, oil
funnel, LPG/propane hose, spark plug socket wrench,
and battery charger.
3.
Remove and discard the packing tray.
4.
Unfold the top of the plastic bag enclosing the generator.
5.
Carefully cut the vertical corners of the carton to access
the generator.
6.
Recycle or dispose of the packaging materials properly.
CARTON CONTENTS
• User manual
• Quick Start Guide/Maintenance Schedule
• LPG/propane hose with regulator
• Remote start key fob (attached to recoil starter)
• 0.63 Quart (0.6 Liter) bottle of SAE 10W-30 Oil
• Battery charger
• Spark plug socket wrench
• Oil Funnel
• Screwdriver
If any parts are missing, contact our service team at
service@wpowereq.com or call 1-855-944-3571.
INITIAL OIL FILL
NOTICE
THIS GENERATOR HAS BEEN SHIPPED WITHOUT
OIL
. Do not attempt to crank or start engine before it has
been properly serviced with recommended oil. Failure to
add engine oil before starting will result in serious engine
damage.
NOTICE
Use of 2-stroke/cycle oil or other unapproved oil types
can cause severe engine damage that is not covered
under warranty.
The included, recommended oil type for typical use is
10W-30 engine oil. If running the generator in extreme
temperatures, refer to the following chart.
1.
On a level surface, remove the oil access cover and oil
dipstick.
2.
Using the supplied funnel and oil, add oil into the engine.
Note:
As residual oil from the factory may remain in the
engine, add the oil incrementally near the end of the
bottle to prevent overfilling the engine. See Engine
Oil Level Check in the Maintenance section.
3.
Wipe the oil dipstick clean. Replace the oil dipstick and
hand-tighten.
4.
Replace the oil access cover.
