19
Drain pump
The pump should be inspected if
• the machine does not empty and/or spin
• the machine makes an unusual noise during
draining due to objects such as safety pins, coins
etc. blocking the pump.
Proceed as follows:
• Disconnect the appliance.
• If necessary wait until the water has cooled down.
• Open the pump door.
• Place a container close to the pump to collect any
spillage.
• Release the emergency emptying hose, place it in
the container and remove its cap.
• When no more water comes out, unscrew the
pump guard and remove it. Always keep a rag
nearby to dry up spillage of water when removing
the pump guard.
• Remove any objects from the pump impeller by
rotating it.
P1097
P1096
P1095
• Put the cap back on the emergency emptying hose
and place the latter back in its seat.
• Screw the pump guard fully in.
• Close the pump door.
Important!
Every time you drain the water through the
emergency emptying hose you must pour 2 litres of
water into the main wash compartment of the
detergent drawer and then run the drain program.
This will activate the ECO valve avoiding that part of
the detergent remains unused for the next wash.
Water inlet filter
If you notice that the machine is taking longer to fill,
check that the filter in the water inlet hose is not
blocked.
Turn off the water tap.
Unscrew the hose from the tap.
Clean the filter with a stiff brush.
Screw the hose back onto the tap.
P1090
P1098
132990930.qxd 04/06/2004 08:44 Pagina 19 (Nero/Process Black pellicola)
