TO DOWNLOAD YOUR SETTINGS FROM
THE RECEIVER TO THE REMOTE
TO CLEAR ALL
PROGRAMS FROM
THE REMOTE
NOTES
3. Push the
“Photo set”
button once. You will see the words: On at Dusk, Off
Hour after Dusk. (This means the plugged-in device will be powered ON
when it gets dark, and will shut OFF after set hours.)
4. Push the
“Photo Set”
button repeatedly to cycle through the number of
hours after Dusk that your timer will stay on. 00:00 hour means ON at dust
OFF at dawn.
5. Push the
“One Click Sync”
button. The programs that are set in the
transmitter will upload to the receiver. The words
“ERR”
will appear if
upload failed.
Push the
“Time”
button then Push the
“Mode”
button. The remote will load
the program from the receiver. The words
“LD”
will appear. The words
“ERR”
will appear if the load failed. You need to make sure the remote is paired with
the receiver. The words
“Program 1 ON”
will appear when load finished.
Push the “ON” and “OFF”
button together and hold for
6 seconds. All programs in the
remote will be cleared.
- You can program the Photo Cell timer
to turn OFF at Dawn, or from 1 to 12
hours after Dusk.
- Be sure to place any lights at least 6ft
(1.8m) away from the timer, so that the
bulb does not affect the light sensor.