8
ENGLISH
Installation (continued)
CONNECTING THE DISPOSER TO THE
MOUNTING ASSEMBLY
Elbow
Trap
Fig. 11
Fig . 12
Disposer body
Reset Button
Fig.13
Top
supporting
ring
Bottom
supporting
ring
Tab
Tool
Mount
Step
Sink
Mounting
Assembly
Cushion Mount
Fig.13a
Sink
Tool Mount
- Adjust the disposer position to make the elbow line up with the
trap (see Fig . 11) .
- The disposer must be installed so that the reset button is
readily accessible (see Fig . 12) .
- Make sure the cushion mount is properly in place . Line up
the disposer under the mounting assembly . Lift and guide the
disposer so that all three tabs of the bottom supporting ring
engage the steps of the top supporting ring . Turn the bottom
supporting ring counter-clockwise until it is fully engaged and
the tool mount comes in contact with the top supporting ring .
Insert a screw driver into the tool mount for added leverage, if
needed (see Fig 13a) .
If you are unable to fully engage the bottom supporting ring,
release and lower the waste disposer (see Fig 13b) .
Fig. 13b
