4
CAUTION: For fixtures labeled for outdoor and wet location use, provide a water-tight seal
between the fixture and the mounting surface by using silicone or similar caulking.
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These
fixtures meet all UL specifications.
1. Turn off power at circuit box to avoid possible electric shock.
2. Remove cap nuts 1 (A) from back plate (B) and remove universal mounting plate or cross
bar (C) leaving mounting screws (D) in place.
3. Secure universal mounting plate or cross bar (C) to outlet box (E) (vertically or
horizontally, see fig. 1) with outlet box screws (F) (not included).
4. Identify color coding of fixture wires (see figure 2 on page 11).
5. To connect wires, take black fixture wire (group A from fig. 2) and place evenly against
black outlet box wire. Do not twist wires.
6. Fit wire connector (G) (see fig. 1) over wires and twist until there is a firm connection.
If wire connector (G) easily comes off, reattach and check again for a firm connection.
7. Repeat steps 5 and 6 with the white (group B from fig. 2) fixture and outlet box wires.
8. Partially thread green grounding screw (H) into side hole (I) on mounting plate or cross
bar (C) (see fig. 1).
9. Wrap ground wire from fixture around green grounding screw (H) leaving enough excess
wire to then connect ground wire and outlet box wire with wire connector (G), if applicable.
10. Tighten green grounding screw (H). Do not over tighten.
11. Tuck wires inside outlet box (E) (see fig. 1).
MOUNTING AND WIRING INSTRUCTIONS
FIXTURE ASSEMBLY INSTRUCTIONS
1. Place back plate (B) over mounting screws (D) (see fig. 1).
2. Secure into place with cap nuts 1 (A).
3. Install lamp(s). Do not exceed recommended wattage.
4. Slide glass panels (J) into place inside cage (K).
5. Remove cap nuts 2 (L) from top of cage (K).
6. Raise cage (K) while lining up holes in cover (M).
7. Secure with cap nuts 2 (L).
8. Screw finials (N) to top and/or bottom (if applicable).
12 pg_W-038_EFS_1/04 3/8/05 7:23 AM Page 4
