10
BEFORE OPERATING YOUR APPLIANCE
BEFORE OPERATING YOUR APPLIANCE
FOR THE FIRST TIME
Preparing your appliance for the first time
• Please remove all internal boxes and bags from the
oven before operation.
• Please wipe out the oven interior prior to operation
with warm soapy water and polish dry with a soft
clean cloth. Do not close the oven door until the
oven is completely dry.
• New appliances can have an odour during first
operation. It is recommended to ‘run in’ your oven
before you cook for the first time. Run the oven at
180°C for 2 hours and ensure that the room is well
ventilated.
• DO NOT line the oven with foil, it will damage the enamel.
• Prior to installing accessories, remove all packaging
and remove plastic film from external panels.
• If your appliance is fitted with a mechanical “Auto
Off” timer, make sure it is set to “Off” marker for
manual operation.
Setting the time
If you have purchased a model fitted with an electronic
or programmable timer, you must set the time of day
before you can operate your appliance.
After electrically connecting the appliance, you must set
the time of the day before you can operate your oven.
Touch control electronic clock model WFE914SC,
WVE914SB
• After the appliance has been electrically connected
“12.00” will be displayed and the “clock” indicator
will flash.
• To set the time of day, press – or +. 5 seconds after
the last change, the “clock” indicator will disappear,
confirming the time has been set.
NOTE: The clock has a 24-hour display.
WFEP915SC electronic controller
• After the appliance has been electrically connected,
“12” and the “Set Clock” symbol “ “ will flash.
• To set the time of day “Hours” press the or
buttons.
• Press the “Clock” button and the time of day
“Minutes” will flash and can be set in the same
manner.
• After 5 seconds from the last change, the clock
display will stop flashing, confirming the time is set.
NOTE: The clock has a 24-hour display.
Temp.
Clock
Programmable Controller: models WFE946SC,
WVEP916SB, WVE916SB
• After the appliance has been electrically connected,
the set clock symbol
will flash on the clock
display.
• To set the time of day, press – or +. 5 seconds after
the last change the timer arrow will disappear,
confirming the time has been set. Once the time has
been entered, the clock advances minute by minute.
NOTE: The clock has a 24-hour display.