Westinghouse Outdoor Power Equipment, LLC | 9
COMPONENTS
CONTROL PANEL COMPONENTS
1
10
5
8
9
11
3
2
4
6
77
COMPONENTS
1. Run/Stop Switch:
Push to Run position to start or
Stop position to shut the generator off.
2. Data Center:
Toggle to show voltage, frequency,
total hour meter, and run/maintenance timer.
3. Main Circuit Breaker:
The main circuit breaker
controls total output of all outlets to protect the
generator from overload or short circuit.
4. Voltage Selector Switch:
Select 120 Volts or 240
Volts.
Shut the generator
OFF
before switching
voltages.
5. 120/240 Volt AC, 30 Amp NEMA L14-30R Twist
Lock Receptacle:
Receptacle can supply either
120V or 240V output.
6. 120 Volt AC, 30 Amp NEMA TT-30R Receptacle:
Receptacle can supply a maximum of 30 Amps.
7. 120 Volt AC, 20 Amp Duplex NEMA 5-20R
Receptacles:
Receptacles can supply a maximum of
20 Amps.
8. 20 Amp AC Circuit Breaker:
Circuit breaker limits
the current that can be delivered through the NEMA
5-20R receptacles to 20 Amps.
9. 30 Amp AC Circuit Breaker:
Circuit breaker limits
the current that can be delivered through the TT-
30R receptacle to 30 Amps.
10. Ground Terminal:
The ground terminal is used to
externally ground the generator.
11. CO Sensor indicator lights:
The CO Sensor
monitors for the accumulation of poisonous carbon
monoxide gas. If increasing levels of CO gas are
detected, the CO Sensor automatically shuts down
the engine.
DATA CENTER
Run Time/Maintenance:
Displays current run time.
Resets to zero when shut
down. Maintenance
reminder displayed
when required.
Frequency (Hz):
Displays power output
frequency in Hertz.
Voltage:
Displays current voltage
output.
Lifetime Hours:
Displays the lifetime run
hours.
Mode Button
Push the Mode button to cycle through
the data display modes.
