Westinghouse WGen7500c, User Manual

16 | Westinghouse Outdoor Power Equipment, LLC

3. 

Remove the nut securing the neutral ground wire and 

attach the bonded jumper wire. Reinstall the nut. 

4. 

Reinstall the alternator cover. 

IMPORTANT: 

Apply a new “NEUTRAL UNBONDED” 

Label over the “NEUTRAL BONDED TO 

FRAME” label on the front of the control 

panel.

HIGH ALTITUDE OPERATION

Engine power is reduced the higher you operate above sea 

level. Output will be reduced approximately 3.5% for every 

1000 feet of increased altitude from sea level. 
High altitude adjustment is required for operation at 

altitudes over 5,000 ft. (1524 m). Operation without this 

adjustment will cause decreased performance, increased 

fuel consumption, and increased emissions. 

NOTICE

DO NOT

 operate the generator at altitudes below 2,000 ft. 

(762 m) with the high altitude kit installed. Engine damage 

may occur.

High Altitude Carburetor Kit: Part# 518063

REMOTE START

WARNING

Verify that the area around the generator is clear before 

remote starting the generator.

The remote start key fob included with the generator should  

be attached to the recoil handle or control panel. If your 

unit was shipped without a key fob, contact Westinghouse 

customer service.

The generator can be started remotely from up to 99 feet 

(30 meter) using the remote start key fob. 

Note: 

As the batteries in the remote start key fob drain, 

operational distance will decrease. 

PAIRING THE REMOTE START

Remote replacement batteries: (2) CR2016
Replacement remote start: Part# 100714A

If the remote start key fob is replaced or needs re-paired to 

the generator, follow this procedure.

1. 

Turn the generator battery switch to the ON position. 

The power indicator light will illuminate. 

2. 

Push and hold the red Pairing button on the side of the 

control panel until the START/STOP  button illuminates.

3. 

Push and hold the STOP button on the key fob until the 

START/STOP  button  illumination turns OFF. Release 

the button. The START/STOP button will illuminate after 

the button is released. 

4. 

Push and hold the START button on the key fob until the 

START/STOP  button  illumination turns OFF. Release 

the button. The START/STOP button will illuminate after 

the button is released. 

5. 

Push the Pairing button on the side of the control panel 

until the START/STOP button illumination turns OFF. 

Release the button.

6. 

Turn the generator battery switch to the OFF position. 

The remote is now paired. 

OPERATION