16 | Westinghouse Outdoor Power Equipment, LLC
OPERATION
3.
Remove the nut securing the neutral ground wire and
attach the bonded jumper wire. Reinstall the nut.
4.
Reinstall the alternator cover.
IMPORTANT:
Apply a new “NEUTRAL UNBONDED”
Label over the “NEUTRAL BONDED TO
FRAME” label on the front of the control
panel.
HIGH ALTITUDE OPERATION
Engine power is reduced the higher you operate above sea
level. Output will be reduced approximately 3.5% for every
1000 feet of increased altitude from sea level.
High altitude adjustment is required for operation at
altitudes over 2,000 ft. (762S m). Operation without this
adjustment will cause decreased performance, increased
fuel consumption, and increased emissions.
NOTICE
DO NOT
operate the generator at altitudes below 2,000 ft.
(762 m) with the high altitude kit installed. Engine damage
may occur.
High Altitude Carburetor Kit Part# 518076-1
REMOTE START
Verify that the area around the generator is clear before
remote starting the generator.
The remote start key fob included with the generator should
be attached to the recoil handle or control panel. If your
unit was shipped without a key fob, contact Westinghouse
customer service.
Note:
Remote start-equipped generators must be restarted
with the START/STOP button on the control panel
after an automatic shut-down occurs.
The generator can be started remotely from up to 99 feet
(30 meter) using the remote start key fob.
Note:
As the batteries in the remote start key fob drain,
operational distance will decrease.
PAIRING THE REMOTE START
Remote replacement batteries: (2) CR2016
Replacement remote: Part# 100714A
If the remote start key fob is replaced or needs re-paired to
the generator, follow this procedure.
1.
Turn the generator battery switch to the ON position.
The power indicator light will illuminate.
2.
Push and hold the red Pairing button on the side of the
control panel until the START/STOP button illuminates.
3.
Push and hold the STOP button on the key fob until the
START/STOP button illumination turns OFF. Release
the button. The START/STOP button will illuminate after
the button is released.
4.
Push and hold the START button on the key fob until the
START/STOP button illumination turns OFF. Release
the button. The START/STOP button will illuminate after
the button is released.
5.
Push the Pairing button on the side of the control panel
until the START/STOP button illumination turns OFF.
Release the button.
6.
Turn the generator battery switch to the OFF position.
The remote is now paired.
Summary of Contents for WGen9500c
