Westinghouse WH10000, User Manual

Westinghouse Portable Power | 15

Weather

 – Never operate your generator outdoors during 

rain, snow or any combination of weather conditions that 

could lead to moisture collecting on, in or around the 

generator.

Dry Surface

 – Always operate the generator on a dry 

surface free of any moisture.

No Connected Loads

 – Make sure the generator has no 

connected loads before starting it. To ensure there are no 

connected loads, unplug any electrical extension cords 

that are plugged into the control panel receptacles.

NOTICE

Starting the generator with loads already applied to it could result 

in damage to any appliance being powered off the generator during 

the brief start-up period.

Grounding the Generator

 – The National Electric Code 

(NEC), as well as many local electrical codes, may require 

the generator to be connected to earth ground. The 

most common application that requires a ground rod is 

when you are using the generator as a separately derived 

system to provide back up power to your house. Typically 

this is when a transfer switch has a switched neutral.

As the generator application has many variables that 

cannot be determined by the manufacturer of the 

generator, a licensed electrician will need to determine if a 

grounding rod is needed. 

If a licensed electrician has determine the application 

requires a ground rod, make sure it is connected to earth 

ground by connecting the ground terminal on the control 

panel to earth ground using copper wire (minimum 10 

AWG). Consult a qualified electrician for local grounding 

requirements.

Neutral Bonded: There is a permanent conduct or 

between the generator (stator winding) and the frame.

WARNING

Be sure the generator is properly connected to 

earth ground before operating. The generator 

must be grounded to prevent electrical shock 

due to faulty appliances.

High Altitude Operation

Engine power is reduced the higher you operate above 

sea level. Output will be reduced approximately 3.5% 

for every 1000ft of increased altitude from sea level. 

This is a natural occurrence and cannot be adjusted by 

engine. Increased exhaust emissions can also result 

due to increased fuel mixture. Other issues include hard 

starting, increased fuel consumption and spark plug 

fouling. Contact our service team 

1-855-944-3571

 for 

altitude part kits.

High Altitude Carburetor Kit Part Number: 140545

BEFORE STARTING THE GENERATOR

BEFORE STARTING THE GENERATOR, 

REVIEW SAFETY SECTION STARTING 

ON PAGE 5.

Location Selection

 – Before starting the generator, 

avoid exhaust and location hazards by verifying:

• 

You have selected a location to operate the generator 

that is outdoors and well ventilated.

• 

You have selected a location with a level and solid 

surface on which to place the generator.

• 

You have selected a location that is at least 6 feet 

(1.8 m) away from any building, other equipment or 

combustible material.

•  If the generator is located close to a building, make 

sure it is not located near any windows, doors and/

or vents.

WARNING

Always operate the generator on a level surface. 

Placing the generator on non level surfaces can 

cause the generator to tip over, causing fuel and 

oil to spill. Spilled fuel can ignite if it comes in 

contact with an ignition source such as a very 

hot surface.

NOTICE

Only operate the generator on a solid, level surface. Operating the 

generator on a surface with loose material such as sand or grass 

clippings can cause debris to be ingested by the generator that 

could:

• Block cooling vents

• Block air intake system

OPERATION