14
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE AND REMEDY
REMEDY
The heat setting
changes between
two levels.
• The Power management is activated.
• See the section Power management.
The sensor fields
become hot.
• The cookware is too large or you out it too
near to the controls.
• Put large cookware on the rear cooking
zones if it is necessary.
comes on
• The Automatic Switch Off operates.
• Deactivate the appliance and activate it again.
comes on
• No cookware on the cooking zone.
• Not correct cookware.
• The diameter of the bottom of the
cookware is too small for the cooking zone.
• Put cookware on the cooking zone.
• Use the correct cookware.
• Move cookware to a smaller cooking zone.
and a number
comes on.
• There is an error in the appliance.
• Disconnect the appliance from the electrical
supply for some time. Disconnect the fuse
from the electrical system of the house.
Connect again. If
comes on again, speak
to the service centre.
comes on
• There is an error in the appliance, because
either the cookware boils dry or you’ve used
incorrect cookware. Overheating protection
for cooking zone operates. The automatic
switch-off operates.
• Deactivate the appliance. Remove the
hot cookware. After approximately 30
seconds, activate the cooking zone again.
If the cookware was the problem, the error
message goes out of the display, but the
residual heat indicator can stay. Let the
cookware become sufficiently cool and refer
to “Cookware for the induction cooking
zone” to see if your cookware is compatible
with the appliance.
WARNING
WARNING
Repairs to the appliance are only to be carried out by
qualified service engineers. Considerable danger to the
user may result from improper repairs.
TIPS & INFORMATION
IMPORTANT
If the appliance has been wrongly operated, the visit
from the customer service technician or dealer may
not take place free of charge, even during the
warranty period.
TROUBLESHOOTING (CONTINUED)