5
INSTALLATION
INSTALLATION INSTRUCTIONS
Built-in appliances
• Only use the built-in appliances after you assemble
the appliance into correct built-in units and work
surfaces that align to the standards.
Connection cable
• Use the correct mains cable of type H05BB-F Tmax
90°C (or higher) for a single phase or two
phase connection.
• Replace the damaged mains cable with a special
cable (type H05BB-F Tmax 90°C or higher). Speak to
your local Service Centre.
To attach the seal
• Clean the worktop in the area of the cut out section.
• Bond the seal stripe supplied on the lower edge
of the appliance along the outer edge of the glass
ceramic. Do not extend it. Let stay the cut ends in the
middle of one side. When, you cut it to length (add
some mm), push the two ends together.
Assembly
min.
500mm
min. 50mm
min. 50mm
min.
5mm
Make sure a ventilation space of 5mm directly below the
benchtop is included in the installation and is kept free.
The warranty does not cover functional failures caused by
the lack of adequate ventilation
WARNING
WARNING
Refer to “Safety information” chapter.
TIPS & INFORMATION
IMPORTANT
Before the installation, note down the serial number (Ser.
Nr.) from the rating plate at the front of this manual. The
rating plate of the appliance is on its lower casing.
