22
OPERATION
2. Move the fuel shutoff valve to the ON position
(see Figure 15).
Figure 15 – Fuel Shutoff Valve in the ON Position
3. Move the choke lever to the ON position (see
Figure 16) if starting a cold engine. To re-start a
warm engine, leave the choke lever in the OFF
position.
Figure 16 – Choke Lever in the ON Position
4. Push the engine control switch into the RUN
position (see Figure 17).
Figure 17 – Engine Control Switch in the RUN Position
5. Firmly grasp the recoil starter handle and pull
it slowly until you feel increased resistance. At
this point, pull it briskly up and away from the
generator (see Figure 18). Do not allow the starter
handle to snap back against the engine, but
instead return it gently to prevent starter damage.
Do not allow the starter cord to rub against other
parts of the generator.
Figure 18 – Recoil Starter Handle
6. As the engine starts running and stabilizes,
gradually move the choke lever back to the OFF
position.
7. Connect electrical cords or devices into the 240-
Volt AC and/or 12-Volt DC outlets, as required.
Switch the 240-Volt AC Main Circuit Breaker to
the ON position and then switch the 240-Volt AC
Circuit Breakers for Outlets A and B (if equipped)
to the ON position; allow a few seconds between
switching on Outlets A and B so that the generator
can stabilize.
Summary of Contents for WHXC3750
Page 4: ...4...
Page 55: ...55 NOTES...
