Westinghouse WWF1044M7WA, User Manual

24

        www.westinghouse.co.nz

24         www.electrolux.co.th 

 CARE AND CLEANING

8.

You must DISCONNECT the appliance 

from the electricity supply, before you can 

carry out any cleaning or maintenance 

work.

The water we use normally contains lime. 

It is a good idea to periodically use a 

water softening powder in the machine. 

Clean the appliance only with soap and 

warm water. Fully dry all the surfaces.

Do not use alcohol, solvents or 

chemical products.

Do this separately from any laundry 

washing, and according to the softening 

powder manufacturer's instructions. 
This will help to prevent the formation of 

lime deposits. 

8.2 Descaling

8.1 External Cleaning

Leave the door open for a while. This 

helps to prevent mould and stagnant 

smells forming inside the appliance. 
Keeping the door open after a wash will 

also help to preserve the door seal.

8.3 After Each Wash

The washing powder and additive 

dispenser drawer should be cleaned 

regularly. 
Remove the drawer by pressing the 

catch downwards and by pulling it out. 

8.5 Cleaning The Dispenser 

Drawer

8.4 Maintenance Wash With

“Tub Clean” Program

To aid cleaning, the top part of the 

additive compartment should be 

removed.

With the use of low temperature washes 

it is possible to get a build up of residues 

inside the drum.
We recommend to use “Tub Clean” 

program to clean the drum regularly to 

remove any residue.

The drum should be empty of laundry.

Press Start/Pause to start the program.

Select the “Tub Clean” program.

To run a maintenance wash:

WARNING! 

CAUTION! 

25

ENGLISH

Flush it out under a tap to remove any 

traces of accumulated powder.

Having removed the drawer, use a small 

brush to clean the recess, ensuring that 

all washing powder residue is removed 

from the upper and lower part of the 

recess. Replace the drawer and run the 

rinse program without any clothes in the 

drum.

8.6 Cleaning The Drawer

Recess

8.7 Cleaning The Pump

The appliance does not drain the water.
The drum cannot turn.
The appliance makes an unusual noise 

because of the blockage of the drain 

pump.
The display shows an alarm code 

because of the problem with water 

drain.

Regularly examine the drain pump 

and make sure that it is clean.

Clean the pump if:

1. Disconnect the mains plug from the 

mains socket.

WARNING!

2. Do not remove the filter while the 

appliance is operating. Do not clean 

the drain pump if the water in the 

appliance is hot. The water must be 

cold before you clean the drain pump.

To clean the drain pump:

1. Open the drain pump door.

2. Place a suitable water container  

below the recess of the drain pump 

to collect the water that flows out.
Press the two levers and pull forward 

the drainage duct to let the water flow 

out.