22
www.westinghouse.com.au / www.westinghouse.co.nz
DAILY USE - DRYING (Only)
6.
The water tap must be open
and the drain hose must be
positioned in the sink or
connected to the drain pipe.
Make sure the load size does not
exceed the maximum drying
capacity of the machine.
2.
Press the On/Off button to turn on the
machine.
1.
Turn the knob to set a wash program
which can select drying option (refer
to Program Chart on page 11),
according to your clothes then press
Mode
touchpad to switch your
machine to
Dry Only Mode
.
3.
If you wish to select an automatic
drying, press the “Dryness Level”
option until the icon corresponding to
the required dryness level appears on
the display. (see page 15)
4.
5.
Press “Start/Pause ” touchpad to
start the program. The time remaining
is updated every minute.
6.
If you wish to select a timed drying,
press the “Time Dry ” option
repeatedly until desired drying time
reached. (see page 14)
After anti-crease phase finish, the
door lock indicator “ ” goes off.
The display will show “ ”.
The display will show “ ” and
“Anti Crease ( )” icon is lit.
The door lock indicator “ ” is still
on.
The appliance will perform the anti-
crease phase for approximately 10
minutes.
If you wish to open the door
during the anti-crease phase
or interrupt it, press
Start/Pause touchpad.
The acoustic signal will operate.
-
-
-
-
At the end of the program :
7.
Press “On/Off” button to switch the
machine off.
8.
9.
At the end of each drying cycle,
the temperature of your clothing
will be high. For your safety,
please leave the door open to
let your clothes cool before
removing your laundry.
If a program is not compatible
with the drying option selected,
the symbol “ ” will flash on
display.
DAILY USE - WASHING & DRYING (Non-Stop Program)
7.
Load the laundry and add detergent
and fabric softener. Make sure the load
size does not exceed the maximum
drying capacity of the machine.
1.
Turn the knob to set a wash program
which can select drying option (refer to
Program Chart on page 11), according
to your clothes then press
Mode
touchpad to switch your machine to
Wash + Dry Mode
.
2.
Select the required options by
pressing the relevant touchpads. If
possible, do not select a spin speed
lower than that proposed by the
machine to avoid unnecessary longer
drying time therefore saving energy.
3.
Set the dryness level by pressing
“
Dryness Level
” touchpad.
The display will then show the whole
duration of wash & dry cycle.
4.
Start the program by pressing
Start/Pause touchpad. The time
remaining is updated every minute on
the display.
5.
7.1 Washing P “Dryness Level” Option