Westken
information manuals and technical assistance
General Manual for UN35 Butt Welder
Westken,
190 van Eden crescent, Rosslyn, Pretoria, South Africa.
www.westken.co.za (Tel; 0027 12 541 6064/6065 fax; 0027 12 541 8086)
3
Some simple explanations of words and terms can be found on our website. Words that
can be found on our website will be in
bold italics
.
A more in depth explanation of the welding processes and equipment will be covered in
other sections on the
Westken
info page.
Chapter one
The layout and walk around of an UN35 air operated Butt welder.
(UN35 Butt welder)
1)
Front side of the machine
2)
Right Hand side of the machine.
3)
Rear of the machine
4)
Left Hand side of the machine
5)
Top of the machine.
Chapter two
The installation of a UN35 air operated Butt welder
Please read
Introduction to Spotwelding for newcomers & others on our website
(UN35 Butt welder)
1)
Bolting the machine down.
2)
Cable sizes and fusing.
3)
Water pipes.
4)
Machine Fusing with supply cable not exceeding 10m
Chapter three
The operation of a UN35 Butt spot welder
(UN35 Butt welder)
1)
How the machine works allowing a weld to take place.
2)
Basic startup setting of the timers on an air operated Butt welder.
3)
The setup of the solid state control as used on the UN35 Butt welder
4)
Info for Customers purchasing spares.
So you have seen what we want to discuss, it helps a bit if you know what machine you
have, look at the list and away we go.
