Westken
information manuals and technical assistance
General Manual for UN35 Butt Welder
Westken,
190 van Eden crescent, Rosslyn, Pretoria, South Africa.
www.westken.co.za (Tel; 0027 12 541 6064/6065 fax; 0027 12 541 8086)
5
2)
7 selectable programs
3)
Solid state membrane facia
(3)
Rear of the machine
There are two hinged doors in the rear of the machine that give access to the firing board
and the thyristor unit. The main supply point for electrical power is located behind these
doors. Access to the rear of the clamping cylinders located on the top of the machine.
The FRL (filter/lubricator/regulator) can be seen on top of the machine.
(4)
Left hand side of the machine
There is only a blank panel on this side of the machine;
(5)
Looking at the top of the machine
Moving to the front of the machine we now look at the top of the machine where we find;
1) Clamping jaws on the left.
2) Upset cylinder on the right side.
3) The 1/4" 5/2 24vdc body port two solenoid valves at the rear of the machine.
4) The FRL (filter/regulator/lubricator) back right hand side.
General Note on machine weights and sizes are for guideline purposes only;
due to
machine improvement and client specific requirement Westken reserves the right to
change machine size / mass specifications without notice.
3) UN35
Approximately 200kg
800 wide x 800 deep x 950 high
Chapter two
Installation of a
“UN35
” air operated Butt welding machine.
(UN35 Butt welder)
1)
Bolting the machine down.
2)
Cable sizes and fusing.
3)
Water pipes
4)
Machine Fusing with supply cable not exceeding 10m
Please Note:
Installation must only be undertaken by a’
“Qualified electrician”