3
PRODUCT MANUAL
1800 358 101
sales.au@westlab.com
www.westlab.com.au
+64 9 553 3677
sales.nz@westlab.com
www.westlab.co.nz
646 568 5391
sales.us@westlab.com
www.westlab.com
1 877 822 1455
sales.ca@westlab.com
www.westlab.com
Australia
New Zealand
United States
Canada
2. Technical Specification
Temperature Range
Boiling at 100°C
Temperature Control
Constant boiling, no control
Heater Indicator
Indicates ON = heating, off safety cut out has fired
Heater Power
220 – 240V, 1000W
Voltage
230V models 50Hz - 60Hz
Tank Capacity
8.8L
Number of Holes
12 holes x 80mm diameter
External Dimensions
425mm W x 321mm D x 90mm H
Packed Dimensions
510mm W x 400mm D x 170mm H
Packed Weight
5kg
3. Safety Precautions
Read the following safety precautions prior to using the unit.
•
This product is designed for laboratory use only. Always follow sensible
laboratory practices.
•
Always fill the tank prior to connection to the electrical supply.
•
Use caution when topping up and draining the tank. If the unit is not used in accordance
with the instructions, then the basic safety procedures may be affected.
•
The mains supply cord fitted to this unit is heat resistant and should be replaced with
an equivalent type by a qualified electrician.
•
Ensure that the power supply has a safety earth (ground) terminal.
•
Connect to a mains power supply with RCD protection if possible.
•
Ensure that the mains switch and the power supply connector are accessible during use.
•
Before using any cleaning or decontamination methods, please refer to the Maintenance
section within this document to ensure that the proposed method will not damage the unit.
•
Connect only to a power supply with the corresponding voltage to that specified on the
rating label positioned on the rear of the unit. Ensure that the substances being heated
present no risk or a hazard such as an explosion, implosion, or the release of toxic or
flammable gases. When heating substances where the liberation of gasses occurs,
use suitable extraction methods.
•
Only use liquids specified within this product manual in their specified
temperature ranges.
•
Always drain the tank prior to moving the unit.
•
Over voltage category II [IEC 644] and Pollution Degree II [IEC 644].
