3
8. GENERAL CLEANING:
The turnover of solution must be determined by the user
to satisfy acceptable cleaning results of the finished article.
If the contamination is heavy and difficult to remove,
a pre-rinse in a heated solution could be enough to soften
and loosen unwanted debris for ultrasonic cleaning.
At the other end of the scale, after the items have been
removed it is essential that a final rinse be performed
to remove any residue that remains on the cleaned parts.
•
•
•
9. INSTALLATION:
When locating a position for the cleaner, consideration
should be given to the following:
Generous circulation of air all around the cleaner.
Surrounding air free of dirt, contamination
and high temperatures.
Away from possible liquid splatter.
Easy access for manual adjustment.
•
•
•
•
10. OPERATION:
Insert the single phase 10A plug into a 240-volt, AC outlet.
Pour cleaning fluid of your choice into the tank.
Switch the supply mains ON.
The unit is now ready to operate.
•
•
•
•
WESTLAB
FXP10M
OPERATING
MANUAL
FOR M/MH:
Turn the Mechanical timer switch to the desired time
setting and ultrasonic cavitation will occur in the liquid.
FOR D/DH:
To set interval time, press min or sec for desired setting.
Press start/stop for countdown start.
When countdown finishes, 30 seconds of beeps are given,
and the relay is off.
To terminate the countdown process, press the start/stop key.
To re-start the same cycle of countdown,
press start/stop key once.
To change the current count down setting, press min
or sec to set the desired value.
•
•
•
•
•
•
