5/12/2017
TECH-538/D.W.O. 23160
Page 17 of 189
2
Warnings
Warning symbols used in this document
Below there are the symbols used in this document:
This symbol warns the user of possible danger. Failure to heed this warning may lead to
personal injury or death and/or severe damage to equipment.
This symbol identifies information about operating the equipment in a particular manner that
may damage it or result in a system failure. Failure to heed this warning can lead to total failure
of the equipment or any other connected equipment.
This symbol draws attention to information that is essential for understanding the operation
and/or features of the equipment.
ICoT Installation and Operation Warnings
•
The ICoT series contain aluminum and is a potential risk of ignition by impact or
friction. Care must be taken into account during installation and use to prevent
impact or friction.
•
Never remove enclosure cover or make/break electrical connections with power
connected to the unit.
•
Perform all wiring in accordance with site and local codes and the National Electric
Code ANSI-NFPA-70 (US) or the Canadian Electric Code Part I (Canada) for the
appropriate area classifications.
•
Confirm that the ICoT model being installed is approved for the hazardous area
(consult unit’s identification label).
•
Protect the unit from exposure to aggressive substances or atmospheres to ensure
that hazard rating is not compromised.
•
Disconnect power to the ICoT and shut off the inlet air supply before conducting any
valve service or maintenance. Avoid the introduction of any contaminants into the
valve.
•
Before using these products with fluids/compressed gases other than air or for
non-industrial applications, consult the factory. This product is not intended for use
in life support systems.
•
Installation in poorly ventilated confined areas, with any potential of gases other
than oxygen being present, can lead to a risk of personnel asphyxiation.
•
Do not operate radio transmitters at less than 1 meter from the device.
