5/12/2017
TECH-538/D.W.O. 23160
Page 18 of 189
3
Mechanical and Pneumatic Installation (Valve Setup)
The correct configuration, installation and assembly is crucial not only to get the best performance from
the positioner, but also to avoid damaging the positioner as well as other parts like the actuator and
other accessories attached to them. Please follow the following instruction carefully.
Rotary Actuator - Direct Mounting.
Step 1.
Mount the bracket and inner beacon coupler on the actuator. If the actuator shaft has a tapped hole,
fasten using proper flat head screw. If actuator does not have a tapped hole, fasten using set screws on
side of coupler. See Figure 2-1
Figure 3-1 - Bracket / Coupler Mounting
Bracket
Flat
Head
Screw
Set
Screw
Inner
Beacon
Coupler
Actuator
Accessory
Mounting
Shaft