5/12/2017
TECH-538/D.W.O. 23160
Page 53 of 189
In the ICoT 5400,
the keypad buttons are located on the right side of the LCD. Just select the CAL entry,
select the ACAL option, then press CAL button again and it will start the Auto calibration.
See pictures below:
Figure 8-9 – Position of the ICoT5400 keypad buttons
ATTENTION:
If both “Up” and “Down” entries are pressed while in the main screen the unit
will go to the “PASSWORD” setup screen (See picture). This function is dedicated for the
internal use only and should not be used by the operator. To exit “PASSWORD” setup
function press simultaneously “Up” and “Down” buttons again.
Figure 8-10– Password screen
The calibration functions of the positioner are organized into the following five menus:
•
ACAL
(Automatic Calibration)
•
MCAL
(Manual Calibration)
•
Cofg
(Configuration)
•
Stro
(Manual Override of Input Signal)
•
Node Add
(Manual Node Address Configuration)
Section 10 ( Menu Tree) presents a basic menu tree diagram of the local display. The menus and
functions used in the calibration and configuration procedures are described in the following sections.
Westlock Controls
ICoT FF Rev 4.1.0
25.5
°
C
PASSWORD
↑↓
: 0___
Enter Password
