5/12/2017
TECH-538/D.W.O. 23160
Page 55 of 189
On-board DIP switches
ICoT 5400 Configuration DIP-Switch
The DIP switch SW4 is located in the left side of the display. Open the electronic board canister cover to
access it. The SW4 has four configuration switches. The function of each configuration switch is the
following:
1 – Write Lock – Block the user to write any configuration in the device
2 – Simulate – Enable or Disable the FF Simulate parameter
3 – Factory Default Initialization (See Section 8.2.2)
4 – Auxiliary – Not used
Figure 8-12 – ICoT5400 DIP switch SW4
ICoT 6400 Configuration DIP-Switch
The DIP switch SW2 located in the right side of the display has four configuration switches.
The function of each switch is the following:
1 – Write Lock – Block the user to write any configuration in the device
2 – Simulate – Enable or Disable the FF Simulate parameter
3 – Factory Default Initialization (See Section 8.2.2)
4 – Auxiliary – Not used
Figure 8-13 – ICoT6400 DIP switch SW2