5/12/2017
TECH-538/D.W.O. 23160
Page 69 of 189
Manual Valve Stroke to override of Input Signal using On-Board Pushbuttons (Stro)
This menu gives access to the following three stroking functions via the pushbuttons:
1.
Adjs
- Adjustment of positioner to any position using the pushbuttons
2.
OP
- Open, sets the valve to the full open position
3.
CLs
- Close, sets the valve to the full closed position
These functions set the positioner to digital control mode (
network independent
) and therefore allow override of
the network setpoint control signal.
The positioner has a feature which allows the operator to override the analog setpoint signal and change valve
position from the pushbuttons. This is done from the
Stro (Manual Override-Stroke Menu).
Enter calibration as
described in Section 8.9.3 and use the “Down” button to cycle to the
Stro
menu.
Enter this menu and control the position of the valve.
Figure 8-23 – Positioner’s parameters - stroke configuration routine
