5/12/2017
TECH-538/D.W.O. 23160
Page 96 of 189
4.
After the download is successful, start the “Monitoring Mode…” and check the status of each input
and output to be sure that this application is running well. (See next picture)
Figure 8-51 – NI Conf Tool in Monitoring mode
5.
If the application is not running as expected, see Chapter 9 (Maintenance and Repair) for
diagnostics information and for troubleshooting. Also, as this is not a real process application, the
results may not the same of a real world application, where a positioner is continuously modifying
the valve position while AI is the transmitter PV of the process where the valve is assembled.
