29/4/06
TECHUK-23 REV 0
Page 1 of 6
Installation & Operating Instructions
Westlock Accutrak / Quantum 2800
With Optional MAGNUM Proximity Switches.
WARNING: The Accutrak / Quantum should
always be handled with care when the cover
is removed and wired to an electrical power
1. Attach the correct mounting bracket and
adapter to the Accutrak / Quantum housing
with the hardware provided.
2. Operate the actuator to full closed position.
3. Attach the Accutrak /
Quantum
and mounting
bracket to the actuator.
4. To remove the cover, unscrew the cover locking
bracket and unscrew cover in a counter clockwise
5. To adjust the sensor triggers, loosen the retaining
6. Operate actuator from one end of stroke to the
other several times to check switch operation.
WESTLOCK CONTROLS UK Ltd.
LLLLLLLLLLLLLLLLLLLLL
22 CHAPMAN WAY, TUNBRIDGE WELLS, KENT, TN2 3EF, ENGLAND. TEL: 44 (0)1892 516277 FAX: 44 (0)1892 516279
7. The correct wiring diagram for the product is
shown on the inside of the Accutrak / Quantum
cover. Please follow carefully.
FIELD WIRING & INSTALLATION.
8. Field wiring must be carried out in accordance
with site, local and National Electrical Codes.
green screw.
cable glands. When mounting the flameproof
enclosure in the hazardous area,
only
9. The ground wire should be secured under the
10. The cerification applies to equipment
without
11.
All
unused cable entries
must
be plugged with
suitably certified plugs that can maintain an
12. For ambient temperatures below -10
€
C and
above +60
€
C, use field wiring suitable for
both
suitably certified cable glands, that can maintain
minimum and maximum ambient temperatures.
0539
II 2 GDT80€C
PRODUCT CERTIFICATION.
EEx d IIC T6
DEMKO 03 ATEX 135478X
an ingress protection level of IP6
7
, shall be
used.
ingress protection level of IP6
7
.
screw and slide up or down to suit.
Complete this for both sensors.
source.
direction.
