13
Safety Notes
Do not overload the remote-controlled sockets. Overloading may
destroy the sockets or cause damages, i.e. fire. The maximum
connected power rating must not exceed 3600 W.
ATTENTION! Before undertaking any connection or maintaining
work e. g. changing the illuminant, due to the single-pole cut-off
and the commonly used transmission frequency, the input lead
of the connected consumer load has to be voltage-free! To
switch off the unit with the remote control is not enough.
Only consumers that are ohm resistive loads and inductive loads
powered by 230 V AC are allowed to be operated. Therefore do
not connect washing machines, dryers or similar appliances. Do
not use the remote-controlled sockets with power electric tools,
rotating machines or other devices outdoors such as lawnmower
etc.
After programming the sockets, place the cover back on the
housing and tighten. Do not operate the sockets without cover.
Do not disassemble the units; they do not contain parts
serviceable by you. A modification is not permitted; this would
void the operating license for the units. In case of malfunction,
contact our customer support department.
If the housing or electrical components become damaged due to
dropping or when moisture enters the housing, do not operate
the unit further more.
Do not disassemble, burn, or short-circuit batteries and do not
attempt to recharge non-rechargeable batteries.
