11
Using
Inserting/Replacing the Batteries
(not included)
1. Push the lamp from the mounting bracket (7). Press the latch of
the battery compartment cover and open the battery
compartment (8) located at the rear side of the lamp.
2. Insert 3 new batteries of the type LR03 (AAA) into the battery
compartment. Pay attention to the proper polarity of the batteries.
The polarity is printed inside the battery compartment.
3. Close the battery compartment with the cover and attach the
lamp to the mounting bracket.
Replace the batteries when the light of the LEDs gets weaker.
Wall Mounting
Use 2 screws or nails to attach the mounting bracket (7) at the
desired location on the wall. Use the mounting bracket as a
template for the screw holes. The lamp can be installed
horizontally, vertically or overhead at the ceiling.
Put the lamp on the mounting bracket and push it to the left until
it audibly snaps in.
You can remove the lamp quickly and easily at any time from the
mounting bracket in case you want to exchange the batteries.
Using
1. Use the two LED angle adjustment knobs (3) at both sides of the
lamp to setup the desired angle of the LEDs.
2. Set the mode selection switch (5) located at the side of the lamp
to the position “NORMAL”. Then press the on/off key (1) to switch
on the lamp. Press the on/off key again to dim the LEDs (4).
Press the on/off key a third time to switch off the lamp.
3. Set the mode selection switch (5) to the position “30S” or “60S”.
The lamp will light up each time the motion sensor (2) detects
motion within its field of view. The light will turn off after 30
seconds respectively 60 seconds.
