Using
14
Inserting the Batteries into the LED Flashing Light
1. Open the red cover (1b) by inserting the finger nail into
the notch (2b) on the front side of the housing. Lever out
the cover.
2. Insert 2 batteries of the type LR03 (AAA) into the battery
compartment (5b). Pay attention to the proper polarity of
the batteries. The polarity is printed inside the battery
compartment.
3. Make sure that the rubber seal (3b) is evenly placed on
the housing. Put the reflector (6b) on the housing and
firmly press down the cover. Make sure the cover audi-
bly snaps in and that it is tightly closed.
4. Replace the batteries when the light beam becomes
faint.
Using the LED Flashing Light
1. Use the clip (8b) to attach the LED flashing light e.g. to
your clothes, to the belt or to the knapsack.
2. Press the ON/OFF button (7b) of the LED flashing light
to switch on the light.
3. Each time you press the ON/OFF button, the light
switches to the following of the 6 available flashing
modes.
4. The eighth time you press the ON/OFF button, the LED
flashing light switches off.
