B E L 1 8 0 S E M I - A U T O M A T I C R A N D O M T A P E S E A L E R
6
Installing & Removing the Tape Heads
Tape dispensing heads are mounted with pins on their sides that fit into corresponding slots in the
upper and lower tape head mounting positions.
Bottom Tape Head
The bottom tapehead is installed and removed by using the manual lever to rotate it up and out of
the bottom conveyor rollers. It is first necessary to raise the top tapehead holder to be out of the
way using a switch on the main controls enclosure.
1. With the machine power turned on and all the guard doors closed, turn the TAPE
HOLDER selector switch on the main control panel to ‘UP’. The top tape head holder
will raise it to its maximum height and lock in position, making the bottom tape head
accessible. The green light on top of the machine will flash quickly indicating that the
machine guard door can be opened to reach the bottom tape head.
2. Pull the bottom tapehead holder lever towards you to rotate the bottom head up and out of
the bottom machine frame. The lever has a latching pin to secure it in the up position.
65-34-5 4/21/10
