Model Type
Interface path: WFLY → [General Menu] → [Model Type]
Airplanes and gliders are available in 6 main wing types and three tail types. Helicopters can choose
from six swash types. There is a default preset for each type of model data.
Model type: helicopter, airplane, glider, multicopter
Helicopter swash: H-1, H-3, HE3, HR3 (120°), HN3 (120°), H-4, H-4X.
Wing Types (Airplane, glider):
- Wing: 1 aileron, 2 ailerons, 2 ai 1 flap, 2 ai 2 flaps (normal, first page); 2 ailerons, 2
ai 1 flap, 2 ai2 flaps (delta wing, second page)
-Tail: Normal, V-wing, aileron elevator (normal (normal, first page)); normal, winglet (delta wing, second
page)
Save setting: After the type is selected, click the “OK” button in the lower right corner to save the
settings.
Example of operation: setting the model to
helicopter (H-3)
1 Select (click) "
" to pop up the model
Model Type
list.
Model type
V-Tail
1 AIL
Model Type
OK
Glider
Airplabe
Helicopter
Multicopter
Model Type
Model type
1/2
H-1
Normal
H-4
AIL
ELE2
ELE
PIT
HN3(120°)
AIL
PIT
ELE
HR3(120°)
PIT
AIL
ELE
PIT
AIL
ELE
HE3
H-3
PIT
ELE
AIL
Model type
V-Tail
1 AIL
Model Type
OK
When the "Type Selection" is set, the type of "model" and
"wing (swash)" are selected, and the selection interface will
pop up in turn. If you click the title [Model Type] in the upper
left corner, exit [Model Type], the settings do not save the
changes.
①
②
③
2 Select (click) "Helicopter" to bring up the swash
list.
055
General Menu
3 Select (click) “H-3” to return to the default [
Model
Type
] interface, and click the “Confirm” button to
save the changes. Finish setting!
When the "Model Function" is replaced
(the data in [Model menu] will be reset!)!
Therefore, you must confirm that you do
not need these data, or use the [Model
select] function to "copy" the backup of the
model data, and then do the replacement
operation. Same as above, such as
"swash plate", "wing type" and "tail type"
operation, the corresponding operation
will clear and change the current model
data to the default parameters of the newly
selected type, so it is necessary to reset
the features of [Model menu] .
NOTICE
Summary of Contents for ET Series
Page 52: ...052 Linkage Setting ...
Page 130: ...130 ...
