Throttle Hold
Interface path: WFLY → [Model Menu] → [Throttle Hold]
This function sets the throttle in the cut position during landing. The speed of the throttle servo can be
adjusted.
Note: The throttle hold is associated with flight conditions and the throttle hold function must be set
separately with different flight conditions.
When flying, be sure to turn off the
“idle” function switch to start the
engine at idle down.
The set throttle lock output position
Current throttle position
Set the response speed of the
[Throttle Hold] function switch
with Range 0~100 and default
0, and there is no conflict with
the [Condition] delay.
Place the stick on the throttle
position you want to hold with
Range 0%~50%, default 17% ,
click the value button or the
confirmation button to get the
position(POS.).
Function application instruction
When the electronic helicopter is performing a landing action, the propeller is generally required to
operate at low idle speed in order to land safely and smoothly.
However, the working principle of electric helicopters and oil-powered helicopters is different. The
setting here needs to distinguish the “hold position” of the throttle according to the model power, and make
adjustments according to the actual application.
The operation of the electric helicopter is more flexible than of the oil engine, so it can be set low or
closed (depending on the actual situation).
The engine of the oil-powered helicopter runs, and the acceleration and deceleration dynamic response
time is much longer than that of the motor, so the "hold position" needs to be higher than the motor type.
17%
Throttle hold
Status
Switch
- -
INH
Hold pos.
Delay
0
Control switch position
086
Model Menu\Airplane
WARNING
Summary of Contents for ET Series
Page 52: ...052 Linkage Setting ...
Page 130: ...130 ...
