80
MODEL MENU \ MULTICOPTER
THROTTLE CUT
The selected hardware cut switch adjusts the ratio value when the throttle and throttle lever are idle
down, until the engine can be completely shut down.
In addition, verify that the throttle link is not tightened or that the servo is not overloaded.
Interface path: HOME/MON.→ [MODEL MENU]→[THROTTLE CUT]
Safely and easily to turn off the engine. Throttle cut provides an easy way to stop the engine from
running. Generally speaking, it can be realized by dialing a hardware switch in an idle state. This function
cannot be triggered when the throttle is high to prevent any misoperation. The position and direction of the
switch must be selected because the initial setting is [--].
* When both [Throttle Hold] and [Throttle Cut] are enabled, the function of [Throttle Hold] has the highest
priority.
Cut position setting
3 Turn on the selected “cut control switch”, the engine stick is in the idle down state, adjust the rate until
the engine (motor) stops completely.
2 Click the “Switch” button to pop up the “Switch Assignment” interface and select the control switch.
1 Status is switched to "ACT”
Please pay attention to the throttle connection here, do not let the servo exceed the travel.
* Fly Mode: set "Fly Mode" control switch in "Model Menu" → "Fly Condition".Switch through the switch,
respectively for function setting.
The set cut position
Current position of throttle stick
Function control, default [--]
Press the left and right keys
to adjust the value or press the
ok key to intercept the position
parameters of the STICK.
Range 0%-50%, default 17%
Set the throttle trigger position
DANGER
The "cut position" must not
be set higher than the lowest
speed of throttle position. It is dangerous if the
engine runs at high speed.
Summary of Contents for ET08
Page 83: ...83 ...
