1 3
System Settings Menu Introduction
1.Model Parameters
●
Function
Model parameters function totally have 10
machines for the user to choose, you can select
any of them to setting.
●
Settings
Press the MENU button to boot into the “System
Settings" menu, use Up / Down keys to
select the "model parameter settings", and
press the “OK ” key into the function interface,
as shown above.
The steps of setting is as follows:
1. Using the up / down keys to select different
models.
2. Selected the options, press OK key to select .
3. Settings successfully, press EXIT key to exit.
2.Model Settings
Model settings can be used to set to the helicopters, airplane as you needed.
●
Function
●
Settings
Press the MENU button to boot into the "System
Settings" menu, use Up / Down keys to select
"Model Settings", press the OK key into this
function interface, as shown above.
The steps of setting is as follows:
1. Up / Down keys to select the model.
2. Click OK key to confirm.
3. Settings finished, press EXIT key to return to
superior menu,meanwhile it automatically store
settings value.
3.
Coaching / Simulation
◆
Normal: normally use the model, RF 2.4GHz
work, do not support the trainer.
◆
Trainer mode: use the unit as a trainer, use the
training cable connect the other one as a student
machine. control by the RE2.4machine,to the K4
switch. Not switch K4 is sending to the trainer
machine signal, when push the switch K4 is
sending the student machine signal.
◆
Simulator Mode: This mode will turn off RF 2.4G
in order to facilitate learning with other remote
control. Or connect with the computer to simulate
the flight to reduce power consumption to increase
the use of time.
●
Function
Note:
For security, the above mode switch to take e ffect after reboot.
Helicopter Functions
INSTRUCTION MANUAL
WFT07 REMOTE CONTROL DEVICE