Selection Refer the instroduction on page
17
Selection Refer the instroduction on page
17
Selection Refer the instroduction on page
18
Selection Refer the instroduction on page
18
Selection Refer the instroduction on page
19
Selection Refer the instroduction on page
19
1 Monitor
2 Dual rate
3 Servo reverse
4 End point
5 Sub trim
6 Trim
2 8
7.Flaperon mixing
●
Function
●
Settings
This feature is to use two mixers in the aileron, to
make aileron have a mixer like flap function.
Press the power button to boot into the
"Preferences" menu,use Up / Down arrow to
select the "Flaperon mixing", press OK key to
enter the function interface, as above.
The steps of settings is as follows:1. Using the up
/ down keys can choose to the edit item.
2. Selected the options, press the + / - key to edit the
data. Long press OK key to restore the default
values.
3. Set successfully, press EXIT key to retrun.
Introduction of System Settings Menu
Introduction of Parameter Settings Menu
1.Model parameters
2.Model Setting
3.Coaching / Simulation
4.Stick settings
5.Stick calibration
6.Restore factory settings
7.Tone settings
8.Contrast settings
9.Power supply scheme
10.Version Information
Selection Refer the instroduction on page
16
Selection Refer the instroduction on page
16
Selection Refer the instroduction on page
15
Selection Refer the instroduction on page
15
Selection Refer the instroduction on page
15
Selection Refer the instroduction on page
14
Selection Refer the instroduction on page
14
Selection Refer the instroduction on page
13
Selection Refer the instroduction on page
13
Selection Refer the instroduction on page
13
INSTRUCTION MANUAL
WFT07 REMOTE CONTROL DEVICE
Airplane Function